Engine sensors · Petrol and diesel

P0123 Throttle / pedal position sensor A signal high

Standard definition: Throttle/Pedal Position Sensor/Switch A Circuit High

SeverityHigh
Is it safe to drive?With care, short distances
Estimated cost$70 – $720
Can you check it yourself?Yes, the first steps

What does P0123 mean?

The throttle position (TPS A) sensor signal is above the upper limit. It is usually a broken ground wire, the signal shorted to 5 V, or a faulty sensor. This sensor reports how far the throttle is open; on cars with electronic throttle, two sensors are compared for safety.

With care, short distances: Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.

P0123 symptoms

P0123 causes (most to least common)

  1. Most common Ground wire broken
  2. Signal wire shorted to 5 V
  3. Faulty sensor
  4. Connector unplugged

How do you check and fix P0123?

  1. Measure the ground wire continuity.
  2. Check the connector.
  3. Measure the sensor signal with the ignition on.

P0123 repair cost

Depending on the cause, roughly $70 – $720 (parts + labor; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.

Related fault codes

Frequently asked questions

What does fault code P0123 mean?

P0123 means "Throttle/Pedal Position Sensor/Switch A Circuit High": Throttle / pedal position sensor A signal high. The throttle position (TPS A) sensor signal is above the upper limit. It is usually a broken ground wire, the signal shorted to 5 V, or a faulty sensor. This sensor reports how far the throttle is open; on cars with electronic throttle, two sensors are compared for safety.

Can you drive with P0123?

With care, short distances. Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.

What causes a P0123 fault?

Most common causes: ground wire broken, signal wire shorted to 5 V, faulty sensor. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.

How much does a P0123 repair cost?

Depending on the cause, it costs roughly $70 – $720 (parts + labor; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.

Will clearing the P0123 code fix the problem?

No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.

Engine sensors codes

All engine sensors codes → · All OBD fault codes →

This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.