Engine sensors · Petrol and diesel

P0220 Throttle / pedal position sensor B circuit fault

Standard definition: Throttle/Pedal Position Sensor/Switch B Circuit Malfunction

SeverityHigh
Is it safe to drive?With care, short distances
Estimated cost$70 – $720
Can you check it yourself?Yes, the first steps

What does P0220 mean?

The engine computer saw a general fault in the throttle position (TPS B) sensor circuit. It is the second (backup) position sensor on the electronic throttle; comparing it with sensor A protects against unintended throttle opening. When the sensor signal is lost the ECU runs on a substitute value, which causes symptoms such as limp mode.

With care, short distances: Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.

P0220 symptoms

P0220 causes (most to least common)

  1. Most common Faulty sensor
  2. Loose or corroded connector
  3. Broken wire / short circuit
  4. Internal throttle body fault

How do you check and fix P0220?

  1. Unplug the connector, check and clean the pins.
  2. Measure the 5 V reference, ground and signal voltage at the sensor (typical: a 0.5–4.5 V signal running opposite or parallel to sensor A).
  3. Inspect the wiring where it rubs against the engine block.

P0220 repair cost

Depending on the cause, roughly $70 – $720 (parts + labor; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.

Related fault codes

Frequently asked questions

What does fault code P0220 mean?

P0220 means "Throttle/Pedal Position Sensor/Switch B Circuit Malfunction": Throttle / pedal position sensor B circuit fault. The engine computer saw a general fault in the throttle position (TPS B) sensor circuit. It is the second (backup) position sensor on the electronic throttle; comparing it with sensor A protects against unintended throttle opening. When the sensor signal is lost the ECU runs on a substitute value, which causes symptoms such as limp mode.

Can you drive with P0220?

With care, short distances. Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.

What causes a P0220 fault?

Most common causes: faulty sensor, loose or corroded connector, broken wire / short circuit. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.

How much does a P0220 repair cost?

Depending on the cause, it costs roughly $70 – $720 (parts + labor; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.

Will clearing the P0220 code fix the problem?

No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.

Engine sensors codes

All engine sensors codes → · All OBD fault codes →

This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.