P0122 Throttle / pedal position sensor A signal low
What does P0122 mean?
The throttle position (TPS A) sensor signal is below the lower limit. Usually the signal wire is shorted to ground, the sensor is faulty, or the connector is unplugged. This sensor reports how far the throttle is open; on cars with electronic throttle, two sensors are compared for safety.
With care, short distances: Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
P0122 symptoms
- Delayed response or no response to the accelerator
- Limp mode (revs stuck at 1,500–2,000)
- Rough idle
- Harsh shifts on an automatic gearbox
P0122 causes (most to least common)
- Most common Signal wire shorted to ground
- Faulty sensor
- Connector problem
- Loss of the 5 V reference
How do you check and fix P0122?
- Measure the signal voltage with the ignition on.
- See whether the value changes when you unplug the connector.
- Look for crushed or melted wiring.
P0122 repair cost
Depending on the cause, roughly $70 – $720 (parts + labor; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.
Related fault codes
Frequently asked questions
What does fault code P0122 mean?
P0122 means "Throttle/Pedal Position Sensor/Switch A Circuit Low": Throttle / pedal position sensor A signal low. The throttle position (TPS A) sensor signal is below the lower limit. Usually the signal wire is shorted to ground, the sensor is faulty, or the connector is unplugged. This sensor reports how far the throttle is open; on cars with electronic throttle, two sensors are compared for safety.
Can you drive with P0122?
With care, short distances. Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
What causes a P0122 fault?
Most common causes: signal wire shorted to ground, faulty sensor, connector problem. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.
How much does a P0122 repair cost?
Depending on the cause, it costs roughly $70 – $720 (parts + labor; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.
Will clearing the P0122 code fix the problem?
No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.
Engine sensors codes
All engine sensors codes → · All OBD fault codes →
This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.