P0107 Manifold absolute pressure (MAP) sensor signal low
What does P0107 mean?
The manifold absolute pressure (MAP) sensor signal is below the lower limit. Usually the signal wire is shorted to ground, the sensor is faulty, or the connector is unplugged. The MAP sensor measures the pressure in the intake manifold; engine load and, on turbo cars, boost pressure are calculated from it.
With care, short distances: Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
P0107 symptoms
- Loss of power
- Surging idle
- Higher fuel consumption
- Limp mode on a turbo car
P0107 causes (most to least common)
- Most common Signal wire shorted to ground
- Faulty sensor
- Connector problem
- Loss of the 5 V reference
How do you check and fix P0107?
- Measure the signal voltage with the ignition on.
- See whether the value changes when you unplug the connector.
- Look for crushed or melted wiring.
P0107 repair cost
Depending on the cause, roughly $50 – $360 (parts + labor; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.
Related fault codes
Frequently asked questions
What does fault code P0107 mean?
P0107 means "Manifold Absolute Pressure/Barometric Pressure Circuit Low": Manifold absolute pressure (MAP) sensor signal low. The manifold absolute pressure (MAP) sensor signal is below the lower limit. Usually the signal wire is shorted to ground, the sensor is faulty, or the connector is unplugged. The MAP sensor measures the pressure in the intake manifold; engine load and, on turbo cars, boost pressure are calculated from it.
Can you drive with P0107?
With care, short distances. Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
What causes a P0107 fault?
Most common causes: signal wire shorted to ground, faulty sensor, connector problem. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.
How much does a P0107 repair cost?
Depending on the cause, it costs roughly $50 – $360 (parts + labor; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.
Will clearing the P0107 code fix the problem?
No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.
Engine sensors codes
All engine sensors codes → · All OBD fault codes →
This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.