P0106 Manifold absolute pressure (MAP) sensor range / performance problem
What does P0106 mean?
The value read by the manifold absolute pressure (MAP) sensor does not match the other sensors and the way the engine is running. The sensor may have drifted (reading a wrong but plausible value), or there is a real problem in the system it measures. The MAP sensor measures the pressure in the intake manifold; engine load and, on turbo cars, boost pressure are calculated from it.
Drivable: You can keep driving, but don't ignore it; have it checked at the first opportunity.
P0106 symptoms
- Loss of power
- Surging idle
- Higher fuel consumption
- Limp mode on a turbo car
P0106 causes (most to least common)
- Most common Sensor drift / contamination
- Cracked vacuum hose to the sensor
- Sensor coated with oil / soot (on diesels with EGR)
- A real problem in the measured system
- Poor connector contact
How do you check and fix P0106?
- In live data, compare the sensor value with the value expected under similar conditions.
- Clean or check the sensor; if needed, replace it with a genuine or good-quality aftermarket part.
- Check for a mechanical problem (leak, blockage) in the related system.
P0106 repair cost
Depending on the cause, roughly $50 – $360 (parts + labor; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.
Related fault codes
Frequently asked questions
What does fault code P0106 mean?
P0106 means "Manifold Absolute Pressure/Barometric Pressure Range/Performance": Manifold absolute pressure (MAP) sensor range / performance problem. The value read by the manifold absolute pressure (MAP) sensor does not match the other sensors and the way the engine is running. The sensor may have drifted (reading a wrong but plausible value), or there is a real problem in the system it measures. The MAP sensor measures the pressure in the intake manifold; engine load and, on turbo cars, boost pressure are calculated from it.
Can you drive with P0106?
Drivable. You can keep driving, but don't ignore it; have it checked at the first opportunity.
What causes a P0106 fault?
Most common causes: sensor drift / contamination, cracked vacuum hose to the sensor, sensor coated with oil / soot (on diesels with EGR). For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.
How much does a P0106 repair cost?
Depending on the cause, it costs roughly $50 – $360 (parts + labor; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.
Will clearing the P0106 code fix the problem?
No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.
Engine sensors codes
All engine sensors codes → · All OBD fault codes →
This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.