P0120 Throttle / pedal position sensor A circuit fault
What does P0120 mean?
The ECU saw a general fault in the throttle position (TPS A) sensor circuit. This sensor reports how far the throttle is open; on cars with electronic throttle, two sensors are compared for safety. When the sensor signal is lost, the ECU runs on a substitute value; this causes symptoms such as a delayed response or no response to the accelerator.
With care, short distances: Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
⚠️ On most cars, an electronic throttle needs an adaptation (relearn) after it has been cleaned.
P0120 symptoms
- Delayed response or no response to the accelerator
- Limp mode (revs stuck at 1,500–2,000)
- Rough idle
- Harsh shifts on an automatic gearbox
P0120 causes (most to least common)
- Most common Faulty sensor
- Loose or corroded connector
- Broken wire / short circuit
- Throttle body dirty or its motor weak
How do you check and fix P0120?
- Unplug the connector, check and clean the pins.
- Measure the 5 V reference, ground and signal voltage at the sensor (typical: ~0.5 V with the throttle closed, ~4.5 V fully open).
- Inspect the wiring where it rubs against the engine block.
P0120 repair cost
Depending on the cause, roughly $70 – $720 (parts + labor; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.
Related fault codes
Frequently asked questions
What does fault code P0120 mean?
P0120 means "Throttle/Pedal Position Sensor/Switch A Circuit Malfunction": Throttle / pedal position sensor A circuit fault. The ECU saw a general fault in the throttle position (TPS A) sensor circuit. This sensor reports how far the throttle is open; on cars with electronic throttle, two sensors are compared for safety. When the sensor signal is lost, the ECU runs on a substitute value; this causes symptoms such as a delayed response or no response to the accelerator.
Can you drive with P0120?
With care, short distances. Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse. On most cars, an electronic throttle needs an adaptation (relearn) after it has been cleaned.
What causes a P0120 fault?
Most common causes: faulty sensor, loose or corroded connector, broken wire / short circuit. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.
How much does a P0120 repair cost?
Depending on the cause, it costs roughly $70 – $720 (parts + labor; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.
Will clearing the P0120 code fix the problem?
No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.
Engine sensors codes
All engine sensors codes → · All OBD fault codes →
This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.