P0102 Mass air flow (MAF) sensor signal low
What does P0102 mean?
The mass air flow (MAF) sensor signal is below the lower limit. Usually the signal wire is shorted to ground, the sensor is faulty, or the connector is unplugged. The MAF sensor measures how much air enters the engine; the ECU calculates the fuel to inject from it.
With care, short distances: Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
P0102 symptoms
- Rough idle
- Hesitation or loss of power when accelerating
- Black smoke (diesel) or high consumption
- Stalling
P0102 causes (most to least common)
- Most common Signal wire shorted to ground
- Faulty sensor
- Connector problem
- Loss of the 5 V reference
How do you check and fix P0102?
- Measure the signal voltage with the ignition on.
- See whether the value changes when you unplug the connector.
- Look for crushed or melted wiring.
P0102 repair cost
Depending on the cause, roughly $40 – $520 (parts + labor; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.
Related fault codes
Frequently asked questions
What does fault code P0102 mean?
P0102 means "Mass or Volume Air Flow Circuit Low": Mass air flow (MAF) sensor signal low. The mass air flow (MAF) sensor signal is below the lower limit. Usually the signal wire is shorted to ground, the sensor is faulty, or the connector is unplugged. The MAF sensor measures how much air enters the engine; the ECU calculates the fuel to inject from it.
Can you drive with P0102?
With care, short distances. Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
What causes a P0102 fault?
Most common causes: signal wire shorted to ground, faulty sensor, connector problem. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.
How much does a P0102 repair cost?
Depending on the cause, it costs roughly $40 – $520 (parts + labor; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.
Will clearing the P0102 code fix the problem?
No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.
Engine sensors codes
All engine sensors codes → · All OBD fault codes →
This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.