P0110 Intake air temperature (IAT) sensor circuit fault
What does P0110 mean?
The ECU saw a general fault in the intake air temperature (IAT) sensor circuit. The IAT sensor measures the temperature of the air entering the engine; the fuel quantity and ignition advance are adjusted from it. When the sensor signal is lost, the ECU runs on a substitute value; this causes symptoms such as hard starting in the cold.
With care, short distances: Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
P0110 symptoms
- Hard starting in the cold
- Higher fuel consumption
- Slight loss of power
- Check engine light
P0110 causes (most to least common)
- Most common Faulty sensor
- Loose or corroded connector
- Broken wire / short circuit
- Faulty MAF housing on sensors combined with the MAF
How do you check and fix P0110?
- Unplug the connector, check and clean the pins.
- Measure the 5 V reference, ground and signal voltage at the sensor (typical: the voltage falls as the temperature rises; about 2.5–3.5 V at 20 °C).
- Inspect the wiring where it rubs against the engine block.
P0110 repair cost
Depending on the cause, roughly $25 – $280 (parts + labor; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.
Related fault codes
Frequently asked questions
What does fault code P0110 mean?
P0110 means "Intake Air Temperature Circuit Malfunction": Intake air temperature (IAT) sensor circuit fault. The ECU saw a general fault in the intake air temperature (IAT) sensor circuit. The IAT sensor measures the temperature of the air entering the engine; the fuel quantity and ignition advance are adjusted from it. When the sensor signal is lost, the ECU runs on a substitute value; this causes symptoms such as hard starting in the cold.
Can you drive with P0110?
With care, short distances. Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
What causes a P0110 fault?
Most common causes: faulty sensor, loose or corroded connector, broken wire / short circuit. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.
How much does a P0110 repair cost?
Depending on the cause, it costs roughly $25 – $280 (parts + labor; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.
Will clearing the P0110 code fix the problem?
No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.
Engine sensors codes
All engine sensors codes → · All OBD fault codes →
This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.