P0124 Throttle / pedal position sensor A circuit intermittent
What does P0124 mean?
The throttle position (TPS A) sensor signal drops out from time to time. It is usually a loose connector or a wire that loses contact with vibration. This sensor reports how far the throttle is open; on cars with electronic throttle, two sensors are compared for safety.
Drivable: You can keep driving, but don't ignore it; have it checked at the first opportunity.
P0124 symptoms
- Delayed response or no response to the accelerator
- Limp mode (revs stuck at 1,500–2,000)
- Rough idle
- Harsh shifts on an automatic gearbox
P0124 causes (most to least common)
- Most common Loose connector
- Broken internal wire (cutting out with vibration)
- Corroded pin
How do you check and fix P0124?
- With the engine running, gently wiggle the connector and wiring and watch in live data whether the signal drops out.
- Clean the pins and check the connector lock.
P0124 repair cost
Depending on the cause, roughly $70 – $720 (parts + labor; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.
Related fault codes
Frequently asked questions
What does fault code P0124 mean?
P0124 means "Throttle/Pedal Position Sensor/Switch A Circuit Intermittent": Throttle / pedal position sensor A circuit intermittent. The throttle position (TPS A) sensor signal drops out from time to time. It is usually a loose connector or a wire that loses contact with vibration. This sensor reports how far the throttle is open; on cars with electronic throttle, two sensors are compared for safety.
Can you drive with P0124?
Drivable. You can keep driving, but don't ignore it; have it checked at the first opportunity.
What causes a P0124 fault?
Most common causes: loose connector, broken internal wire (cutting out with vibration), corroded pin. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.
How much does a P0124 repair cost?
Depending on the cause, it costs roughly $70 – $720 (parts + labor; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.
Will clearing the P0124 code fix the problem?
No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.
Engine sensors codes
All engine sensors codes → · All OBD fault codes →
This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.