P2128 Accelerator pedal position sensor E signal high
What does P2128 mean?
The signal of sensor E in the electronic accelerator pedal is high. The pedal has two sensors for safety; when one fails, the ECU goes into limp mode and restricts throttle response.
With care, short distances: Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
P2128 symptoms
- The car doesn't speed up when you press the accelerator (limp mode)
- Revs stay at a fixed value
- Warning light, sometimes the EPC light
P2128 causes (most to least common)
- Most common Pedal sensor (integral with the pedal) worn
- Poor contact in the pedal connector
- Wiring damage
- A floor mat trapping the pedal (rare)
How do you check and fix P2128?
- Unplug and refit the pedal connector and check the pins.
- In live data, watch the pedal percentage and both sensors' voltages; if they jump as you press the pedal, the sensor is worn.
- The pedal is usually replaced as a unit; an adaptation may be needed afterwards.
P2128 repair cost
Depending on the cause, roughly $95 – $480 (parts + labor; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.
Related fault codes
Frequently asked questions
What does fault code P2128 mean?
P2128 means "Throttle/Pedal Position Sensor/Switch E Circuit High Input": Accelerator pedal position sensor E signal high. The signal of sensor E in the electronic accelerator pedal is high. The pedal has two sensors for safety; when one fails, the ECU goes into limp mode and restricts throttle response.
Can you drive with P2128?
With care, short distances. Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
What causes a P2128 fault?
Most common causes: pedal sensor (integral with the pedal) worn, poor contact in the pedal connector, wiring damage. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.
How much does a P2128 repair cost?
Depending on the cause, it costs roughly $95 – $480 (parts + labor; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.
Will clearing the P2128 code fix the problem?
No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.
Engine sensors codes
All engine sensors codes → · All OBD fault codes →
This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.