Engine sensors · Petrol and diesel

P2123 Accelerator pedal position sensor D signal high

Standard definition: Throttle/Pedal Position Sensor/Switch D Circuit High Input

SeverityHigh
Is it safe to drive?With care, short distances
Estimated cost$95 – $480
Can you check it yourself?Mechanic needed

What does P2123 mean?

The signal of sensor D in the electronic accelerator pedal is high. The pedal has two sensors for safety; when one fails, the ECU goes into limp mode and restricts throttle response.

With care, short distances: Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.

P2123 symptoms

P2123 causes (most to least common)

  1. Most common Pedal sensor (integral with the pedal) worn
  2. Poor contact in the pedal connector
  3. Wiring damage
  4. A floor mat trapping the pedal (rare)

How do you check and fix P2123?

  1. Unplug and refit the pedal connector and check the pins.
  2. In live data, watch the pedal percentage and both sensors' voltages; if they jump as you press the pedal, the sensor is worn.
  3. The pedal is usually replaced as a unit; an adaptation may be needed afterwards.

P2123 repair cost

Depending on the cause, roughly $95 – $480 (parts + labor; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.

Related fault codes

Frequently asked questions

What does fault code P2123 mean?

P2123 means "Throttle/Pedal Position Sensor/Switch D Circuit High Input": Accelerator pedal position sensor D signal high. The signal of sensor D in the electronic accelerator pedal is high. The pedal has two sensors for safety; when one fails, the ECU goes into limp mode and restricts throttle response.

Can you drive with P2123?

With care, short distances. Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.

What causes a P2123 fault?

Most common causes: pedal sensor (integral with the pedal) worn, poor contact in the pedal connector, wiring damage. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.

How much does a P2123 repair cost?

Depending on the cause, it costs roughly $95 – $480 (parts + labor; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.

Will clearing the P2123 code fix the problem?

No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.

Engine sensors codes

All engine sensors codes → · All OBD fault codes →

This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.