P0460 Fuel level sensor circuit fault
What does P0460 mean?
The ECU saw a general fault in the fuel level sensor circuit. The float-type level sensor in the tank drives the fuel gauge and, on some cars, the EVAP tests. When the sensor signal is lost the ECU runs on a substitute value, which causes symptoms such as the fuel gauge reading wrongly or erratically.
With care, short distances: Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
P0460 symptoms
- Fuel gauge reads wrongly or erratically
- Low fuel warning light comes on wrongly
- EVAP tests can't be run
P0460 causes (most to least common)
- Most common Faulty sensor
- Loose or corroded connector
- Broken wire / short circuit
- Float arm stuck
How do you check and fix P0460?
- Unplug the connector, check and clean the pins.
- Measure the 5 V reference, ground and signal voltage at the sensor (typical: the float resistance changes with how full the tank is).
- Inspect the wiring where it rubs against the engine block.
P0460 repair cost
Depending on the cause, roughly £50 – £360 (parts + labour; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.
Related fault codes
Frequently asked questions
What does fault code P0460 mean?
P0460 means "Fuel Level Sensor A Circuit Malfunction": Fuel level sensor circuit fault. The ECU saw a general fault in the fuel level sensor circuit. The float-type level sensor in the tank drives the fuel gauge and, on some cars, the EVAP tests. When the sensor signal is lost the ECU runs on a substitute value, which causes symptoms such as the fuel gauge reading wrongly or erratically.
Can you drive with P0460?
With care, short distances. Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
What causes a P0460 fault?
Most common causes: faulty sensor, loose or corroded connector, broken wire / short circuit. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.
How much does a P0460 repair cost?
Depending on the cause, it costs roughly £50 – £360 (parts + labour; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.
Will clearing the P0460 code fix the problem?
No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.
Engine sensors codes
All engine sensors codes → · All OBD fault codes →
This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.