Engine sensors · Petrol and diesel

P0100 Mass air flow (MAF) sensor circuit fault

Standard definition: Mass or Volume Air Flow Circuit Malfunction

SeverityMedium
Is it safe to drive?With care, short distances
Estimated cost£35 – £420
Can you check it yourself?Yes, the first steps

What does P0100 mean?

The ECU saw a general fault in the mass air flow (MAF) sensor circuit. The MAF sensor measures how much air enters the engine; the ECU calculates the fuel to inject from it. When the sensor signal is lost, the ECU runs on a substitute value; this causes symptoms such as a rough idle.

With care, short distances: Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.

⚠️ Clean a MAF sensor only with a dedicated MAF cleaner spray; a brush, cloth or carburettor cleaner will ruin the sensor.

P0100 symptoms

P0100 causes (most to least common)

  1. Most common Faulty sensor
  2. Loose or corroded connector
  3. Broken wire / short circuit
  4. Air filter dirty or fitted incorrectly
  5. Air leak in the hose after the MAF

How do you check and fix P0100?

  1. Unplug the connector, check and clean the pins.
  2. Measure the 5 V reference, ground and signal voltage at the sensor (typical: on a petrol engine at idle about 0.6–1.2 V).
  3. Inspect the wiring where it rubs against the engine block.

P0100 repair cost

Depending on the cause, roughly £35 – £420 (parts + labour; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.

Related fault codes

Frequently asked questions

What does fault code P0100 mean?

P0100 means "Mass or Volume Air Flow Circuit Malfunction": Mass air flow (MAF) sensor circuit fault. The ECU saw a general fault in the mass air flow (MAF) sensor circuit. The MAF sensor measures how much air enters the engine; the ECU calculates the fuel to inject from it. When the sensor signal is lost, the ECU runs on a substitute value; this causes symptoms such as a rough idle.

Can you drive with P0100?

With care, short distances. Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse. Clean a MAF sensor only with a dedicated MAF cleaner spray; a brush, cloth or carburettor cleaner will ruin the sensor.

What causes a P0100 fault?

Most common causes: faulty sensor, loose or corroded connector, broken wire / short circuit. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.

How much does a P0100 repair cost?

Depending on the cause, it costs roughly £35 – £420 (parts + labour; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.

Will clearing the P0100 code fix the problem?

No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.

Engine sensors codes

All engine sensors codes → · All OBD fault codes →

This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.