P0108 Manifold absolute pressure (MAP) sensor signal high
What does P0108 mean?
The manifold absolute pressure (MAP) sensor signal is above the upper limit. It is usually a broken ground wire, the signal shorted to 5 V, or a faulty sensor. The MAP sensor measures the pressure in the intake manifold; engine load and, on turbo cars, boost pressure are calculated from it.
With care, short distances: Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
P0108 symptoms
- Loss of power
- Surging idle
- Higher fuel consumption
- Limp mode on a turbo car
P0108 causes (most to least common)
- Most common Ground wire broken
- Signal wire shorted to 5 V
- Faulty sensor
- Connector unplugged
How do you check and fix P0108?
- Measure the ground wire continuity.
- Check the connector.
- Measure the sensor signal with the ignition on.
P0108 repair cost
Depending on the cause, roughly £40 – £290 (parts + labour; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.
Related fault codes
Frequently asked questions
What does fault code P0108 mean?
P0108 means "Manifold Absolute Pressure/Barometric Pressure Circuit High": Manifold absolute pressure (MAP) sensor signal high. The manifold absolute pressure (MAP) sensor signal is above the upper limit. It is usually a broken ground wire, the signal shorted to 5 V, or a faulty sensor. The MAP sensor measures the pressure in the intake manifold; engine load and, on turbo cars, boost pressure are calculated from it.
Can you drive with P0108?
With care, short distances. Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
What causes a P0108 fault?
Most common causes: ground wire broken, signal wire shorted to 5 V, faulty sensor. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.
How much does a P0108 repair cost?
Depending on the cause, it costs roughly £40 – £290 (parts + labour; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.
Will clearing the P0108 code fix the problem?
No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.
Engine sensors codes
All engine sensors codes → · All OBD fault codes →
This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.