P0105 Manifold absolute pressure (MAP) sensor circuit fault
What does P0105 mean?
The ECU saw a general fault in the manifold absolute pressure (MAP) sensor circuit. The MAP sensor measures the pressure in the intake manifold; engine load and, on turbo cars, boost pressure are calculated from it. When the sensor signal is lost, the ECU runs on a substitute value; this causes symptoms such as loss of power.
With care, short distances: Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
P0105 symptoms
- Loss of power
- Surging idle
- Higher fuel consumption
- Limp mode on a turbo car
P0105 causes (most to least common)
- Most common Faulty sensor
- Loose or corroded connector
- Broken wire / short circuit
- Cracked vacuum hose to the sensor
- Sensor coated with oil / soot (on diesels with EGR)
How do you check and fix P0105?
- Unplug the connector, check and clean the pins.
- Measure the 5 V reference, ground and signal voltage at the sensor (typical: with the ignition on and the engine off, atmospheric pressure (~100 kPa)).
- Inspect the wiring where it rubs against the engine block.
P0105 repair cost
Depending on the cause, roughly £40 – £290 (parts + labour; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.
Related fault codes
Frequently asked questions
What does fault code P0105 mean?
P0105 means "Manifold Absolute Pressure/Barometric Pressure Circuit Malfunction": Manifold absolute pressure (MAP) sensor circuit fault. The ECU saw a general fault in the manifold absolute pressure (MAP) sensor circuit. The MAP sensor measures the pressure in the intake manifold; engine load and, on turbo cars, boost pressure are calculated from it. When the sensor signal is lost, the ECU runs on a substitute value; this causes symptoms such as loss of power.
Can you drive with P0105?
With care, short distances. Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
What causes a P0105 fault?
Most common causes: faulty sensor, loose or corroded connector, broken wire / short circuit. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.
How much does a P0105 repair cost?
Depending on the cause, it costs roughly £40 – £290 (parts + labour; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.
Will clearing the P0105 code fix the problem?
No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.
Engine sensors codes
All engine sensors codes → · All OBD fault codes →
This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.