P0348 Camshaft position sensor A (bank 2) signal high
What does P0348 mean?
The camshaft position (bank 2) sensor signal is above its upper limit. It is usually a broken ground wire, the signal shorted to 5 V, or a faulty sensor. On V engines it reports the camshaft position of cylinder bank 2.
With care, short distances: Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
P0348 symptoms
- Slow starting
- Misfire
- Loss of power
P0348 causes (most to least common)
- Most common Ground wire broken
- Signal wire shorted to 5 V
- Faulty sensor
- Connector unplugged
How do you check and fix P0348?
- Measure the ground wire continuity.
- Check the connector.
- Measure the sensor signal with the ignition on.
P0348 repair cost
Depending on the cause, roughly £35 – £290 (parts + labour; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.
Related fault codes
Frequently asked questions
What does fault code P0348 mean?
P0348 means "Camshaft Position Sensor A (Bank 2) Circuit High": Camshaft position sensor A (bank 2) signal high. The camshaft position (bank 2) sensor signal is above its upper limit. It is usually a broken ground wire, the signal shorted to 5 V, or a faulty sensor. On V engines it reports the camshaft position of cylinder bank 2.
Can you drive with P0348?
With care, short distances. Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
What causes a P0348 fault?
Most common causes: ground wire broken, signal wire shorted to 5 V, faulty sensor. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.
How much does a P0348 repair cost?
Depending on the cause, it costs roughly £35 – £290 (parts + labour; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.
Will clearing the P0348 code fix the problem?
No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.
Camshaft, crankshaft and variable valve timing (VVT) codes
All camshaft, crankshaft and variable valve timing (vvt) codes → · All OBD fault codes →
This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.