P0336 Crankshaft position sensor A range / performance problem
What does P0336 mean?
The value read by the crankshaft position (CKP) sensor doesn't match the other sensors and how the engine is running. The sensor may have drifted (reading a wrong but plausible value), or there is a real problem in the system it measures. The crank sensor reports engine speed and piston position; without its signal the engine won't run.
Drivable: You can keep driving, but don't ignore it; have it checked at the first opportunity.
⚠️ On cars that stall when warm and restart once cooled, the crank sensor is the most common cause.
P0336 symptoms
- Cranks but won't start
- Sudden stalling while driving (especially once warm)
- Rev counter flickering or dropping
- Misfire
P0336 causes (most to least common)
- Most common Sensor drift / contamination
- Damage to the flywheel teeth (reluctor ring)
- Metal swarf between the sensor and the flywheel
- A real problem in the measured system
- Poor connector contact
How do you check and fix P0336?
- In live data, compare the sensor value with the value expected under similar conditions.
- Clean or check the sensor; if needed, replace it with a genuine or good-quality aftermarket part.
- Check for a mechanical problem (leak, blockage) in the related system.
P0336 repair cost
Depending on the cause, roughly £35 – £290 (parts + labour; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.
Related fault codes
Frequently asked questions
What does fault code P0336 mean?
P0336 means "Crankshaft Position Sensor A Range/Performance": Crankshaft position sensor A range / performance problem. The value read by the crankshaft position (CKP) sensor doesn't match the other sensors and how the engine is running. The sensor may have drifted (reading a wrong but plausible value), or there is a real problem in the system it measures. The crank sensor reports engine speed and piston position; without its signal the engine won't run.
Can you drive with P0336?
Drivable. You can keep driving, but don't ignore it; have it checked at the first opportunity. On cars that stall when warm and restart once cooled, the crank sensor is the most common cause.
What causes a P0336 fault?
Most common causes: sensor drift / contamination, damage to the flywheel teeth (reluctor ring), metal swarf between the sensor and the flywheel. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.
How much does a P0336 repair cost?
Depending on the cause, it costs roughly £35 – £290 (parts + labour; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.
Will clearing the P0336 code fix the problem?
No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.
Camshaft, crankshaft and variable valve timing (VVT) codes
All camshaft, crankshaft and variable valve timing (vvt) codes → · All OBD fault codes →
This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.