P0087 Fuel rail / system pressure too low
What does P0087 mean?
The ECU measured that the pressure in the fuel rail stays well below the requested value. It is common on common-rail diesels and direct-injection petrol engines. The engine may go into limp mode or stall.
With care, short distances: Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.
⚠️ On diesels with neglected fuel filter maintenance, P0087 is very common; a filter change often solves the problem.
P0087 symptoms
- Serious loss of power when accelerating, “limp mode”
- Hard starting or no start
- Hesitation at high revs
- Stalling
P0087 causes (most to least common)
- Most common Blocked fuel filter (most common, especially on diesels)
- Weak low-pressure (tank) pump
- Worn high-pressure pump
- Faulty pressure regulator / metering valve
- Excessive injector return (leak-off)
- Air in the fuel line (diesel)
- Rail pressure sensor reading incorrectly
How do you check and fix P0087?
- Change the fuel filter first; on a diesel, drain the water too.
- Compare the requested and actual rail pressure in live data (on a diesel at least 250–300 bar while cranking).
- Have an injector leak-off test done.
- Have the tank pump outlet pressure and flow measured.
❌ Common mistake: Replacing the high-pressure pump straight away. Do not replace the pump until the filter, the tank pump and injector leak-off have been ruled out.
P0087 repair cost
Depending on the cause, roughly £60 – £2,300 (parts + labour; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.
Related fault codes
Frequently asked questions
What does fault code P0087 mean?
P0087 means "Fuel Rail/System Pressure – Too Low": Fuel rail / system pressure too low. The ECU measured that the pressure in the fuel rail stays well below the requested value. It is common on common-rail diesels and direct-injection petrol engines. The engine may go into limp mode or stall.
Can you drive with P0087?
With care, short distances. Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse. On diesels with neglected fuel filter maintenance, P0087 is very common; a filter change often solves the problem.
What causes a P0087 fault?
Most common causes: blocked fuel filter (most common, especially on diesels), weak low-pressure (tank) pump, worn high-pressure pump. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.
How much does a P0087 repair cost?
Depending on the cause, it costs roughly £60 – £2,300 (parts + labour; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.
Will clearing the P0087 code fix the problem?
No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.
Fuel and air mixture codes
All fuel and air mixture codes → · All OBD fault codes →
This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.