Camshaft, crankshaft and variable valve timing (VVT) · Petrol and diesel

P0340 Camshaft position sensor A (bank 1) circuit fault

Standard definition: Camshaft Position Sensor A (Bank 1 or Single Sensor) Circuit Malfunction

SeverityMedium
Is it safe to drive?With care, short distances
Estimated cost$35 – $320
Can you check it yourself?Yes, the first steps

What does P0340 mean?

The ECU saw a general fault in the camshaft position (CMP) sensor circuit. The cam sensor identifies which cylinder is at its firing point; sequential injection and VVT rely on it. When the sensor signal is lost the ECU runs on a substitute value, which causes symptoms such as slow or hard starting (long cranking).

With care, short distances: Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.

P0340 symptoms

P0340 causes (most to least common)

  1. Most common Faulty sensor
  2. Loose or corroded connector
  3. Broken wire / short circuit
  4. Damage to the camshaft reluctor
  5. Timing belt / chain has jumped a tooth

How do you check and fix P0340?

  1. Unplug the connector, check and clean the pins.
  2. Measure the 5 V reference, ground and signal voltage at the sensor (typical: a 0–5 V square wave on Hall types).
  3. Inspect the wiring where it rubs against the engine block.

P0340 repair cost

Depending on the cause, roughly $35 – $320 (parts + labor; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.

Related fault codes

Frequently asked questions

What does fault code P0340 mean?

P0340 means "Camshaft Position Sensor A (Bank 1 or Single Sensor) Circuit Malfunction": Camshaft position sensor A (bank 1) circuit fault. The ECU saw a general fault in the camshaft position (CMP) sensor circuit. The cam sensor identifies which cylinder is at its firing point; sequential injection and VVT rely on it. When the sensor signal is lost the ECU runs on a substitute value, which causes symptoms such as slow or hard starting (long cranking).

Can you drive with P0340?

With care, short distances. Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.

What causes a P0340 fault?

Most common causes: faulty sensor, loose or corroded connector, broken wire / short circuit. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.

How much does a P0340 repair cost?

Depending on the cause, it costs roughly $35 – $320 (parts + labor; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.

Will clearing the P0340 code fix the problem?

No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.

Camshaft, crankshaft and variable valve timing (VVT) codes

All camshaft, crankshaft and variable valve timing (vvt) codes → · All OBD fault codes →

This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.