P0401 EGR flow insufficient
What does P0401 mean?
When the ECU opened the EGR valve it didn't see the expected effect (a change in MAP/MAF); the EGR passages or valve may be clogged with soot. It is very common on diesels and on cars used for short trips. EGR feeds part of the exhaust gas back into the intake, lowering combustion temperature and NOx emissions.
Drivable: You can keep driving, but don't ignore it; have it checked at the first opportunity.
⚠️ EGR delete (blanking) is done in software, causes problems at the inspection / emissions test and is also illegal.
P0401 symptoms
- Loss of power, limp mode (especially on diesels)
- Shaking or stalling at idle
- Black smoke (diesel)
- Check engine light
P0401 causes (most to least common)
- Most common EGR valve stuck with soot
- EGR passages / cooler blocked
- Faulty valve motor or position sensor
- Connector and wiring problem
- On vacuum-operated types, the vacuum hose / solenoid
How do you check and fix P0401?
- Remove the EGR valve, clean off the soot and check the passages.
- Run an EGR open-close test with a diagnostic tool and watch the position value.
- On electric types, measure the connector and the valve motor resistance.
- An adaptation may be needed after cleaning.
❌ Common mistake: Replacing the valve without cleaning it. Most P0401 cases come from a blocked passage or a sooted-up valve.
P0401 repair cost
Depending on the cause, roughly $95 – $960 (parts + labor; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.
Related fault codes
Frequently asked questions
What does fault code P0401 mean?
P0401 means "Exhaust Gas Recirculation Flow Insufficient Detected": EGR flow insufficient. When the ECU opened the EGR valve it didn't see the expected effect (a change in MAP/MAF); the EGR passages or valve may be clogged with soot. It is very common on diesels and on cars used for short trips. EGR feeds part of the exhaust gas back into the intake, lowering combustion temperature and NOx emissions.
Can you drive with P0401?
Drivable. You can keep driving, but don't ignore it; have it checked at the first opportunity. EGR delete (blanking) is done in software, causes problems at the inspection / emissions test and is also illegal.
What causes a P0401 fault?
Most common causes: eGR valve stuck with soot, eGR passages / cooler blocked, faulty valve motor or position sensor. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.
How much does a P0401 repair cost?
Depending on the cause, it costs roughly $95 – $960 (parts + labor; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.
Will clearing the P0401 code fix the problem?
No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.
EGR and intake system codes
All egr and intake system codes → · All OBD fault codes →
This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.