P0332 Knock sensor signal low (bank 2)
What does P0332 mean?
The expected signal isn't coming from the bank 2 knock sensor. This sensor "hears" pre-ignition (knock) in the engine; when it fails, the ECU retards the ignition timing for safety and the engine loses power.
Drivable: You can keep driving, but don't ignore it; have it checked at the first opportunity.
P0332 symptoms
- Slight loss of power and higher fuel consumption
- Check engine light
- Occasionally audible knocking (on poor-quality fuel)
P0332 causes (most to least common)
- Most common Faulty sensor
- Sensor tightened to the wrong torque
- Connector / wiring (under the intake manifold, hard to reach)
- Mechanical engine noise (rare)
How do you check and fix P0332?
- Check the connector and wiring.
- Measure the sensor resistance / output.
- Tighten the sensor to the correct torque (usually around 20 Nm).
P0332 repair cost
Depending on the cause, roughly $50 – $440 (parts + labor; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.
Related fault codes
Frequently asked questions
What does fault code P0332 mean?
P0332 means "Knock Sensor 2 Circuit Low (Bank 2)": Knock sensor signal low (bank 2). The expected signal isn't coming from the bank 2 knock sensor. This sensor "hears" pre-ignition (knock) in the engine; when it fails, the ECU retards the ignition timing for safety and the engine loses power.
Can you drive with P0332?
Drivable. You can keep driving, but don't ignore it; have it checked at the first opportunity.
What causes a P0332 fault?
Most common causes: faulty sensor, sensor tightened to the wrong torque, connector / wiring (under the intake manifold, hard to reach). For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.
How much does a P0332 repair cost?
Depending on the cause, it costs roughly $50 – $440 (parts + labor; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.
Will clearing the P0332 code fix the problem?
No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.
Ignition and misfire codes
All ignition and misfire codes → · All OBD fault codes →
This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.