Ignition and misfire · Petrol and diesel

P0309 Cylinder 9 misfire

Standard definition: Cylinder 9 Misfire Detected

SeverityHigh
Is it safe to drive?With care, short distances
Estimated cost$70 – $720
Can you check it yourself?Yes, the first steps

What does P0309 mean?

The ECU detected that cylinder 9 isn't firing properly. A misfire on a single cylinder usually comes from that cylinder's spark plug, ignition coil or injector; less often it is a valve or compression problem.

With care, short distances: Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse.

⚠️ Replacing a coil is a 10-minute job on most engines, but use an original or good-quality equivalent.

P0309 symptoms

P0309 causes (most to least common)

  1. Most common Cylinder 9 spark plug worn, oil-fouled or cracked
  2. Faulty cylinder 9 ignition coil
  3. Cylinder 9 injector blocked or leaking
  4. Poor contact in the coil connector / wiring
  5. Low compression in cylinder 9 (valve, piston rings, gasket)

How do you check and fix P0309?

  1. Quickest test: swap the cylinder 9 coil with a neighbouring cylinder's. If the misfire moves to the other cylinder, the fault is in the coil.
  2. Repeat the same method with the spark plug; if the misfire moves with the plug, the plug needs replacing.
  3. If the misfire stays put, have the injector resistance and spray pattern tested.
  4. If all of these are fine, look for a mechanical problem with a compression / leak-down test.

❌ Common mistake: Replacing all the coils at once. Finding the faulty part with a swap test halves the cost.

P0309 repair cost

Depending on the cause, roughly $70 – $720 (parts + labor; an approximate range that varies by garage and region). Jobs such as cleaning a connector or a simple adjustment may cost less than the lower end; replacing a major part comes close to the upper end. Getting the diagnosis right first avoids replacing parts unnecessarily.

Related fault codes

Frequently asked questions

What does fault code P0309 mean?

P0309 means "Cylinder 9 Misfire Detected": Cylinder 9 misfire. The ECU detected that cylinder 9 isn't firing properly. A misfire on a single cylinder usually comes from that cylinder's spark plug, ignition coil or injector; less often it is a valve or compression problem.

Can you drive with P0309?

With care, short distances. Don't set off on a long journey; take it to a garage as soon as possible. Stop if the symptoms get worse. Replacing a coil is a 10-minute job on most engines, but use an original or good-quality equivalent.

What causes a P0309 fault?

Most common causes: cylinder 9 spark plug worn, oil-fouled or cracked, faulty cylinder 9 ignition coil, cylinder 9 injector blocked or leaking. For a definitive diagnosis, live data and any other stored codes should be assessed together with this code.

How much does a P0309 repair cost?

Depending on the cause, it costs roughly $70 – $720 (parts + labor; an approximate range that varies by garage and region). It may be fixed by simply cleaning a connector or may need a part replaced; the correct diagnosis comes first.

Will clearing the P0309 code fix the problem?

No. Clearing the code only switches the light off temporarily; if the fault isn't fixed, the code comes back within a few drives. Recently cleared codes can also be spotted from the OBD readiness monitors — an important check when buying used.

Ignition and misfire codes

All ignition and misfire codes → · All OBD fault codes →

This page is for general information; details may vary by make and engine. For a definitive diagnosis, see an authorised service centre or a specialist mechanic.